Causes and treatment methods of conveyor belt wear

The belt conveyor has excessive wear and tear, including cracks, drilling, rupture, and tearing. To solve this problem, the first step is to identify the cause of the fault and take appropriate measures. Materials have a significant impact on belts or fasteners. The solution is as follows: use the correct design structure of the chute and baffle.

Make vulcanized joints, install impact rollers, and if possible, install the materials first. If the material is placed under the side shield, adjust the gap to the minimum value. The relative loading rate is too high or too low. Solution: Adjust or adjust the speed of the belt. You can also consider using impact resistant rollers.

Conveyor error loading, overflow. The feeding should be carried out according to the direction and speed of the belt. The material should be located at the center of the belt, and the flow of the material should be controlled through the feeder, chute, and side plate. The accumulation of materials is a common cause, and the solution is also simple, with clear stacking of materials. Install cleaning devices, scrapers, and inverted V-shaped covers, and strengthen environmental organization.

Conveyor wear, acid, chemical, thermal, mold, oil damage. Solution: Specially designed for specific conditions and belts, enter the incision, place it between two pieces of grinding material, and use cold patches or long-term repair agents for on-site repair. Seal metal fasteners or use sulfides to enter connectors. Sealed belt conveyor to prevent damage from rain, snow, and sunlight.